Debugger and Programmer of PIC(R) and dsPIC(R) Flash Microcontrollers
The PG164130 is a PICkit 3 in circuit debugger/programmer uses in circuit debugging logic incorporated into each chip with Flash memory to provide a low cost hardware debugger and programmer.The MPLAB PICkit 3 allows debugging and programming of PIC and dsPIC flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB integrated development environment (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ 11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in circuit debugging and in circuit serial programming.
PICkit 3 allows debugging and programming of PIC and dsPIC Flash MCU's
Expensive sockets or adapters are not required
Minimum of additional hardware needed for debug
Built in over voltage/short circuit monitor
Supports low voltage up to 2volts
MPLAB PICkit 3 contains full speed USB interface to host PC
Compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE
Erase of program memory space with verification
Program up to 512K byte flash with the Programmer to go function
Find products functionally similar to this one. Click on one of the following links and you will be taken to a product group page that presents all products in this category that share the given attribute.